In this Elektor Lab Talk excerpt, Elektor engineer Saad Imtiaz shares practical advice on CAD tools, workflows, and 3D printing techniques for designing enclosures and mechanical parts for electronics ...

Most printed-board connectors are either a one-piece receptacle or a two-piece plug and jack. With receptacle (edge) connectors, the printed-circuit board foils extend to an edge of the board and are ...

Hirose has launched a 1.0 mm coaxial connector that complies with the IEEE Std 287 and supports frequencies up to 110 GHz.

Hirose has launched a 1.0mm coaxial connector that complies with the IEEE Std 287 and supports frequencies up to 110GHz.

DaSH Modular Wire-to-Wire Connectors, which use interchangeable cartridges within a single housing to combine power, signal, ...

A year ago, I’ve design reviewed an MCU module for CAN hacking, called TinySparrow. Modules are plenty cool, and even more so when they’re intended for remaking car ECUs. For a while ...

Abstract: Electromagnetic radiation for a commercial printed circuit board (PCB) connector is investigated in this paper. The simulation models of the connector are shown to be validated by comparing ...

The PCB Reflow Hot Plate is a temperature controlled 120 x 70 mm hot plate designed to reflow solder SMD circuit boards. This project was started due to a gap in the commercial solutions for a mid ...

Abstract: PCB traces in backplane are typically routed as striplines, which create near end crosstalk, but theoretically, no far end crosstalk. However, in practice, both near end and far end ...

Chart does not reflect overnight price.