This article describes how Bode plots can be used as a tool to quickly assess if your power supply design will meet the requirements for dynamic control behaviour. Power supplies normally maintain a ...

These three analysis methods are linked together, so this section is organized by control method. In contrast to the large-signal transient response that was reviewed in part 2, we will perform ac ...

Analyzing a power system's stability usually begins with a look at the open-loop Bode plot of a buck or flyback converter's power stage. From this plot, the designer extracts phase and gain data for ...

Negative feedback is used in voltage regulators, point-of-load (POL) regulators, voltage references, operational amplifiers (op-amps), and other electronic circuits in order to produce an accurate ...

It is unlikely that a power operational amplifier will always be employed to drive a purely resistive load. For if that were the case, stability would rarely become a problem. On the other hand, a ...

CATALOG DESCRIPTION: Linear feedback control systems, their physical behavior, dynamical analysis, and stability. Laplace transform, frequency spectrum, and root locus methods. System design and ...